|
How to put griptape on a skateboard - Page 4:
9. Keep the razor angled at 45 degree angle.
Look at the picture below. You want to keep the blade at a 45 degree angle while the top of the blade should slightly point in towards the board.
10. You are almost done!
11. Use your screwdriver to mash down the edges.
Run your screwdriver along the edge of the board. You want to "melt" the edge of the grip into your board so that it does not peel off when you skate. This is the same process as step number 6.
|
|
|
|
