|
How to clean skateboard bearings - step by step with photos - page 4
7. Give them the spin test. Spin them and see if they spin fast. If they do then you are done. If they don't keep spraying and rubbing out the dirt.
8. Put the bearings back in the wheels. The easiest way to do this is to put the bearing on the truck axle and then slide the wheel on to the bearing. Push hard!
9. Finally, tighten the axle nut. This is an important step because you don't want to tighten your nuts too much. Tighten the axle nuts slowly. Right when the nuts stops turning, untighten the nut a bit. If you tighten the nut too much you may crush your bearing sheilds.
|
|
|
|
